BodyCraft BC-F438, Assembly Instructions Manual

Page: 12 / 36

12
F438
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Mounting the height adjuster
1. Remove the bolts, washers and nuts from the already mounted top frame (6 & 7) and remove
the top frame.
࣑ ATTENTION
Keep the bolts, washers and nuts that were attached to the rear uprights. They will be needed
again.
2. Remove the Bar Catch (10) from the front support (4) and slide each one Bar Catch (10) over the
rear uprights (5) with the adjusting knob pointing downwards (Fig. A).
3. Slide the height adjuster (211L & 212 R) onto the respective front support (4).
4. Remount the top frame (6 & 7) to the rear uprights (5) with the bolts, washers and nuts removed
previously.
5. Mount the top frame (7) to the front uprights (4) along with the pulley connector plates (217)
using a total of four 1/2” X 3” Hex Bolts (256), eight 1/2” Larger Washers (266) and four 1/2” Nylon
Nuts (268).
6. Mount the left & right Pulley Connector Plate (215L & 216R) to the outside of the front upright
(4) using a total of 1/2” X 4” Hex Bolts (254), eight 1/2” Larger Washers (266) and four 1/2” Nylon
Nuts (268).
7. Tighten all bolts and nuts.