12
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
and after STEP 2B. Some components may be pre-assembled. Nylon lock nuts will not
fully screw onto bolts, they must be wrench tighten to fully go on.
2A.
Attach Upper Center Cross Frame
(D)
to Uprights
(A)
using:
2 - (#4) M10x30mm Button Head Cap Screw
2 - (#6) Large Flat Washer ID11xOD28mm
2A.
Attach Upper Side Cross Frames
(E)
to Upper Center Cross
Frame
(D)
using:
2 - (#2) M10x75mm Hex Head Bolt
4 - (#5) M10 Flat Washer
2 - (#8) Nylon Lock Nut
2B.
Attach Upper Side Frames
(E)
to Uprights
(A)
using:
2 - (#4) M10x30mm Button Head Cap Screw
2 - (#6) Large Flat Washer ID11xOD28mm
2C.
Attach Weight Horns
(F)
to Uprights
(A)
using:
12 - (#4) M10x30mm Button Head Cap Screw
12 - (#6) Large Flat Washer ID11xOD28mm
12 - (#7) Lock Washer
2D.
Insert Rubber Donuts
(9)
onto Weight Horns
(F)
Summary of Contents for SWT1000
