14
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A.
Attach Seat and Back Frames
(E & F)
to Main Frame
(A)
using:
1 - (#2) M12x220mm Hex Head Bolt
2 - (#12) M12 Flat Washer
1 - (#9) M12 Nylon Lock Nut
2 - (#16)
ø21xø12.5x10mm Bushing
8
- (#17)
ø16xø12.5x8mm Bushing
2B.
Attach Adjustment Bracket
(G)
to Back Frames
(F)
using:
1 - (#1) M12x165mm Hex Head Bolt
2 - (#12) M12 Flat Washer
1 - (#9) M12 Nylon Lock Nut
2 - (#16)
ø21xø12.5x10mm Bushing
2C.
Attach Tube
(28)
to Adjustment Bracket
(G)
using:
1 - (#4) M10x100mm Hex Head Bolt
2 - (#13) M10 Flat Washer
1 - (#10) M10 Nylon Lock Nut
2D.
Attach T-Knob Lock Pin
(20)
and Pop Pin
(21)
to Main Frame
(A)
Summary of Contents for GFID100
