Body Solid GDCC210.1, Assembly Instructions & Owner'S Manual

Page: 12 / 60

12
S T E P
3
A. Insert Pulley (25) into Top Frame (B) and secure using:
One 4 (M10x65 hex head bolt)
One 13 (M10 nylon nut)
Two 28 (steel bushing)
B. Insert Pulley (27) into Top Frame (B) and secure using:
One 2 (3/8” x 3” hex head bolt)
Two 18 (3/8” washer)
One 12 (3/8” nylon nut)
C. Place both Weight Stack Risers (50) onto Base Frame (A) as shown in the diagram.
NOTE: Weight Stack Risers are omitted when using the upgrade 310 Lb Weight Stack.
D. Place a Rubber Donut (35) onto each Weight Stack Riser (50) or onto Base Frame (A) if Weight
Stack Risers (50) have been omitted.
E. Slide both Guide Rods (52) through Rubber Donuts (35) and Weight Stack Risers (50) and into
Base Frame (A). If Weight Stack Risers (50) have been omitted, slide both Guide Rods (52)
through Rubber Donuts (35) and into Base Frame (A).
F. Slide Weight Stack Plates (57) onto Guide Rods (52) one at a time.
G. Connect Selector Bar (53) to Top Plate (51) using:
One 11 (3/8” x 1 3/4” allen head bolt)
One 22 (3/8” spring washer)
H. Thread Pulley Holder (54) into Selector Bar (53) a minimum of
1/2
” using:
One 15 (½” nut)
One 23 (½” spring washer)
I. Slide Pulley (25) into Pulley Holder (54) and secure using:
One 5 (M10x45 hex head bolt)
Two 19 (M10 washer)
One 13 (M10 nylon nut)
J. Slide the Top Plate Assembly just constructed onto Guide Rods (52).
K. Slide Shaft Collars (32) onto Guide Rods (52).
L. Bring Guide Rods (52) toward the pre-drilled holes on Top Frame (B) and secure by pushing
Shaft Collar (32) upwards into the hole. Turn to lock Shaft Collars (32) in place then secure by
tightening M8x8 Allen Screws (10). Make sure Guide Rods (52) are completely secured.
M. Connect Weight Stack Pin (7) to Weight Stack Pin Lanyard (38) and then secure Weight Stack
Pin (7) to Weight Stack (57) at any position.
N. Apply Weight Stack Stickers (44) onto Weight Stack (57) as shown in the diagram starting with
the application of sticker 1 onto Top Plate (51).
Be careful to assemble all components
in the sequence they are presented.
Finger tighten all hardware in this step unless otherwise noted.
RIGHT SIDE ASSEMBLY