Body Solid G3S, Assembly Instructions And Owner'S Manual

Page: 22 / 82

7
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
22
S T E P
A. Attach Flat End Cap (2) to the bottom of the Adjustable Seat Pad Frame (V).
Attach two End Caps (5) to the front and back of the Adjustable Seat Pad Frame (V).
B. Attach Seat Pad (W) to the Adjustable Seat Pad Frame (V) using:
Two 45 (5/16” x 2” hex head bolt)*
Two 59 (5/16” spring lock washer)
Two 58 (5/16” washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
C. Slide Adjustable Seat Pad Frame (V) into Seat Pad Frame (H), and hold in place with Pop Pin (79).
D. Attach two Foam Rollers (19) to the front of the Adjustable Seat Pad Frame (V) using Foam Roller
Shaft (K) and two 1” Round End Cap (9) as shown.
E. Attach Left Leg Hold Down (AA) and Right Leg Hold Down (AB) to Angled Vertical Frame (D)
using:
Two 34 (3/8” x 3 1/4” hex head bolt)*
Two 51 (3/8” nylon lock nut)
*
Tighten these two 3/8” bolts.
F. Attach two Foam Rollers (19) to Left Leg Hold Down (AA) and Right Leg Hold Down (AB) and
hold on with 1” Round End Cap (9) as shown.