Be careful to assemble all components
in the sequence they are presented.
mm
Inch
3
14
S T E P
A.
Attach Seat Frame (H) and Flat Plate (70) to Angled Vertical Frame (D) using:
Two 43 (3/8” x 2 3/4” hex head bolt)
Two 55 (3/8” washer)
Two 51 (3/8” nylon lock nut)
B.
Attach Seat Frame (H) to Main Base Frame (A) using:
One 43 (3/8” x 2 3/4” hex head bolt)
Two 55 (3/8” washer)
One 51 (3/8” nylon lock nut)
C.
Insert two Thick Nylon Bushing (64) into Seat Frame (H) as shown.
D.
Attach Leg Extension (J) to Seat Frame (H) with the pre-installed Shaft (99) as shown, and
using:
Two 30 (1/4” x 9/16” allen bolt)
Two 31 (1/4” washer)
Tighten the two Allen Screws (76) in Seat Frame (H) to lock down Shaft (99).
Insert one End Cap (3) into Seat Frame (H) as shown.
E.
Attach two Foam Rollers (19) to Leg Extension (J) using Foam Roller Bar (K) and two
1” Round End Cap (9) as shown.
Insert Two End Cap (3) into Leg Extension (J) as shown.
F.
Check to make sure Rubber Stop (85) and Jam Nut (84) are attached to Seat Frame (H)
as shown.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 4.
Summary of Contents for G3S
