Body Sculpture BR-1000, Assembly Manual

Page: 6 / 10

5
STEP 4
Assemble the handlebar stem (pt.6) by
locating its base between the rearward
frame bracket using M10 bolt (pt.18),
washer (pt.19), spring washer (pt.26) &
domed nuts (pt 20). Do not tighten too much
as this need to move relatively freely. Link
hydraulic cylinder (pt.11) between forward
frame bracket to handlebar stem using 2
sets of M8 bolt (pt.23), washer (pt.14),
spring washer (pt.25) and M8 domed nut
(pt.15). Again do not over tighten. Push
handlebar (pt.7) through the upper part of
the stem and locate the foam grips (pt.8)
equally on either side of the handlebar.
STEP 6
The rear leg will fold down for convenience.
Simply remove the pull pin and reposition the
leg flat. The pull pin will now go in the lower
hole of the half round bracket.
STEP 5
To mount the footplate assembly, locate the
pedal spindle bar through the hole in the
front of the main frame and push on the
rubber washers (pt.16) right up to the frame.
There should be equal overhang of the
spindle either side of the main frame. Locate
the footplates (pts.9) on the spindle and
secure in position using two sets of M8
domed nut (pt.15), washer (pt.24) and
spring washer (pt.25). Ideally, the nuts want
tightening simultaneously.
Finally, insert the computer (pt.28) to the
computer holder.