Assembly Instructions
After complete assembly: If the computer is
not picking up your hand pulse signal
(or you are getting
inaccurate readings), Please refer to our “Troubleshooting” section on
Page 18
for other troubleshoot issues.
HAND PULSE SIGNAL
A s s e m b l y S t e p 8
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust seat simultane-
ously
Push knob back inward until it clicks and then
tighten it by turning clockwise.
W A R N I N G
Do not remove the
Seat (#70)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#70)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
Connect the
AC Adapter (#71)
into the female socket at the back of the unit.
pre-assembled on the bottom of the
Seat (#70)
and set them aside as they
will be used later in this step.
Attach the
Seat (#70)
onto the
Horizontal Seat Bar (#69)
and make sure
that the single point of the
Seat (#70)
is pointing forward as illustrated
below and then secure with the three
Washers (#30)
and three
Nylon Nuts
(#17)
that were previously removed.
Secure the
Horizontal Seat Bar (#69)
to the
Seat Post (#65)
using one
Knob
Nut (#66)
inserted through one
Washer (#72)
. The
Knob Nut (#66)
can be
loosened to adjust the distance of the seat from the handle bars. Make sure
to tighten the knob after making any adjustment.
If pre-assembled, remove the
Knob Bolt (#63)
on the mouth of the
Main
Frame (#60)
. Insert the
Seat Post (#65)
into the mouth of the post that is
protruding from the
Main Frame (#60)
down a minimum of 4 inches to
engage the lowest hole. Make sure the holes on the
Seat Post (#65)
are facing the front before inserting. Secure the
Seat Post (#65)
(now
with
Seat (#70)
attached) using the (previously removed)
Knob Bolt (#63).
Hardware Required
Page 11
BRM8981
A.
Remove the three
Washers (#30)
and three
Nylon Nuts (#17)
that are
Troubleshooting
Washers
#30. Washer (d8xφ16x1.5 mm)
[3 Pieces]
#72. Washer (d10xφ20x2.0 mm)
[1 Piece]
Others
#63. Knob Bolt
(M16x1.5x15xφ49 mm)
[1 Piece]
#66. Knob Bolt (M10xφ58x32 mm)
[1 Piece]
Nuts
#17. Nylon Nut (M8xH7.5xS13 mm) [3 Pieces]
Note: This power unit is intended to be correctly orientated in a vertical or
floor mount position
ASSEMBLY IS NOW COMPLETE. HOWEVER, PLEASE
READ ALL SAFETY GUIDELINES & WARNING LABELS
BEFORE USING THE UNIT TO AVOID SERIOUS INJURY.
#42 WASHER FOR M10 BOLT,T2.0 1PC
