Connect the
Monitor Wire (Upper) (#01a)
to the
Monitor
Wire (Middle) (#50)
and tuck the wires in the hole of the
Center Post (#28)
to avoid pinching them.
Attach the
Monitor (#01)
to the
Center Post (#28)
by
aligning the holes and securing with four
and four
Washers (#79).
Screws (#02)
Attach the
Hand Pulse Bar (#04)
by aligning it to the
horizontal catch located on the
Center Post (#28)
and
secure using one
Center Post Shroud (#56R)
and
T
Attach the
Center Post Shroud (#56F)
over the
Center Post (#28)
and
Hand Pulse Bar (#04)
as
shown below and secure using two
Screws (#54)
on the
top and one
Screw (#55)
on the bottom.
Attach the
Water Bottle Holder (#73)
by aligning it to
the holes on the
Center Post (#28)
and secure using
two
Screws (#75)
inserted through two
Washers (#74)
.
Connect the
Hand Pulse Wire (#61)
to the hole on the
back of the
Tighten the
T Shape Bolt (#62)
now.
Monitor (#01)
.
Remove the
pre-assembled on the back of the
Monitor (#01)
as set
them aside as they will be used later in this step.
Screws (#02)
and
Washers (#79)
that are
Remove the
Screws (#75)
and
Washers (#74)
that are
pre-assembled on the
Center Post (#28)
and set
them aside as they will be used later in this step.
F
Shape Bolt (#62).
Do not over tighten the
T Shape Bolt
(#62)
now.
Hardware Required
Hardware Required
A s s e m b l y S t e p 7
A s s e m b l y S t e p 6
Note:
Care should be used when mounting or dismounting
the equipment. Before mounting or dismounting,
move the pedal on the mounting or dismounting
side to it lowest position and bring the machine to
a complete stop.
This unit is not equipped with a free-wheel. Pedal
speed should be reduced in a controlled manner.
Page 10
BRM8981
Bolts
#02. Screw (M4x12 mm)
[4 Pieces]
Washers
#79. Washer (d4xФ12x1.0 mm)
[4 Pieces]
Others
#62. T Shape Bolt (M8x60x20 mm)
[1 Piece]
Bolts
Washers
#74. Washer (d4xφ12x1.0 mm)
[2 Pieces]
#54. Screw (ST4.2x19Xφ8 mm)
[2 Pieces]
#55. Screw (ST4.2x25Xφ8 mm)
[1 Piece]
#75. Screw (M4x12 mm)
[2 Pieces]
Assembly Instructions
