Page 7
Note: The holes on these parts must line up in
order for the
Bolt (
#
28)
to go through.
C
A
B
#33 Washer (M6)
[2 pieces]
#28 Hex Bolt (M6x45 mm)
[ 1 piece]
#30 Lock Nut (M6)
[1 piece]
Bolts
Nuts
Washers
#50 Hex Bolt (M6x10 mm)
[ 1 piece]
Assembly Instructions
A s s e m b l y S t e p 3
Hardware Required
A.) Adjustable Ankle Brace Assembly
C.) Ankle Brace Tube Assembly
Slide the
Ankle Brace Tube (#112)
through the corresponding
Take the illustrated assembly which is composed of
parts
(#105),(#104),(#18),
and
(#
09
)
out of the box. Pull up the
Ankle Brace Lock Pin (#18)
as illustrated and, at the
same time, pull the
Adjustable Ankle Brace (#104)
out
of the
Height Adjustment Tube (#105)
SLOWLY. (You will notice
that there is a
Spring (#09)
that pulls downward as you pull the
Adjustable Ankle Brace (#104)
out). After you free the
Adjustable Ankle Brace (#104)
out as shown in drawing A,
rotate it 90 degrees counter-clockwise so that the circular round
holes face toward the
Ankle Brace Lock Pin (#18),
and the long
oval slot faces downward toward the
Hex Bolt (#5
0
).
Insert the
Adjustable Ankle Brace (#104)
back into the
Height Adjustment
Tube (#105)
and release the
Ankle Brace Lock Pin (#18)
.
NOTE: For your safety, always ensure that the
Ankle Brace Lock
Pin (#18)
is fully inserted into the circular round hole setting that
holds your feet snugly before inverting.
Next, insert
Hex Bolt (#50)
through the bottom hole shown in
drawing A and through the long oval slot and tighten.
Please ensure the assembly now looks like drawing B and that
the
Ankle
Brace Lock Pin (#18)
is fully engaged down into a hole.
set of holes on the
Height Adjustment Tube (#105)
. Then,
secure this assembly by using one
Hex Bolt (#28)
, two
Washers
(#33)
and one
Lock Nut (#30)
as sequenced in diagram C.
Long oval slot
facing downward
Rotate
90 degrees
B.) Adjustable Ankle Brace Assembly (II)
Hole for
Step B.
IT8020