Page 5
A
B
A
#34 Washer (M10)
[8 pieces]
#38 Hex Bolt (M10x35 mm)
[2 pieces]
#25 Hex Bolt (M10x30 mm)
[2 pieces]
#29 Lock Nut (M10)
[4 pieces]
Bolts
Nuts
Washers
Assembly Instructions
A s s e m b l y S t e p 1
Hardware Required
B.) Hand Rail Assembly
Align the top hole located on the
Rear Base (#103)
with the
middle
hole located on the
Pivot Bracket
(#40)
. Position the
Right
Hand Rail (#113R)
on the outside of the
Rear B ase ( #103)
and
position one
Safety Hook (#37)
on the inside
of the
Pivot Bracket (#40)
Insert a
Hex Bolt
(#38)
through a
Washer (#34)
followed by the
Safety Hook (#37)
,
Pivot Bracket (#40)
,
Rear
Base (#103), Right Hand Rail (#113R), Washer
(#34)
and secure it with a
Lock Nut (#29).
Align the lower hole located on the
Rear Base
(#103)
with the lowest hole located on the
Pivot
Bracket (#40)
and the lower hole located on
the
Right Hand Rail (#113R).
Insert a
Hex Bolt
(#25)
through a
Washer (#34)
followed by the
Pivot
Bracket (#40)
,
Rear Base (#103),Right Hand Rail
(#113-R),
Washer (#34)
and secure it with one
Lock
Nut (#29)
. Repeat this process on the opposite side.
Please look at the diagrams and make sure
you assembled all of the parts as illustrated.
A.) A-Frame Assembly
Open the pre-assembled A-Frame, which is composed
of
Front Leg Tube (#101)
,
Rear Base (#103)
and left
and right
Cross Support Brackets (#02A-L/R)
. Make
sure that the two
Cross Support Brackets (#02A-L
/
R)
are
fully extended and firmly locked in place by pressing
down on them.
IT8020