Assembly Instructions
A s s e m b l y S t e p 3
Right Crankshaft
Note:
Keep the
Right/Left Pedal Hinge Bolt (#162/163)
perfectly
straight as they go through the
Pedal Connection Joint
(#166)
and the
Crankshaft (#127)
. If the
Right/ Left Pedal
Hinge Bolt (#162/163)
are connected to the
Crankshaft
(#127)
incorrectly, or, the
Special Washer (#164)
does
not fit the
Lock Pin for Pedal Hinge Bolt (#154)
tightly,
damage to the
Right/ Left Pedal Hinge Bolt (#162/163)
and
Crankshaft (#127)
will occur.
Attach the
Pedal Connection Joint (#166)
to the
Right Pedal Tube (#106R)
. Insert a
Hex Bolt (#105)
through the upper
bracket of the
Pedal Connection Joint (#166)
, followed by
Right Pedal Tube (#106R)
then the lower bracket of the
Pedal
Connection Joint (#166)
. Secure them with a
Nylon Nut (#145)
.
Attach three
Caps (#142)
on three
Hex Bolts (#105)
as illustrated in the drawing below.
Align and attach the
Pedal Connection Joint (#166)
on the
Right Pedal Tube (#106R)
to the right
Crankshaft (#127)
. Insert
the
Right Pedal Hinge Bolt (#162)
through
Pedal Connection Joint (#166)
and
Crankshaft (#127)
. Secure the
Right Pedal
Hinge Bolt (#162)
tightly into the
Crankshaft (#127)
by turning CLOCKWISE.
After that, insert a
Lock Pin for Pedal Hinge Bolt (#154)
to the small hole located at the end of the
Pedal Hinge Bolt (#162)
.
Fit the
Special Washer (#164)
over the
Lock Pin for Pedal Hinge Bolt (#154)
and the
Pedal Hinge Bolt (#162)
, then, secure
with a
Spring Washer (#151)
and a
Right Nylon Nut (#149).
Repeat the above process on the left side of the machine.
Remove
Hex Bolts (#105)
and
Nylon Nuts (#145)
that are pre-assembled on the
Pedal Connection Joint (#166)
and set
them aside as they will be used in a later process.
163
148
104R
105
Left Crankshaf
BR
1830
Page
7