BRT1875 BRT2885
Page 10
Assembly STEP 4
Hardware Required
Attach the
Left/Right Pedals
(#45/#46)
onto the
Left/Right
Pedal Tubes (#03/#04)
as shown in the drawing below using a
total of six
Hex Bolts
(#21)
, six
Washers
(#33)
, and six
Nylon
Nuts
(#40)
.
On the left side, attach the
Left Foot Pedal
(#73)
to the front of
Left Pedal Tube
(#03)
using one
Hex Bolt (#24)
through one
Washer
(#33)
and
Pop Pin
(#56)
safety ring and secure with
one
Washers (#33)
and one
Nylon Nut (#40)
.
Then insert a
Pop-pin
(#56)
into the front hole of the
Left Foot
Pedal
(#73)
.
Repeat this process on the other side.
Note: Care should be used when mounting or dismounting the machine.
Before mounting or dismounting, move the pedal on the mounting or
dismounting side to its lowest position and bring the machine to a
complete stop. This unit is not equipped with a free-wheel. Pedal speed
should be reduced in a controlled manner.
Front Foot Pedal with 3 settings
#21 Hex Bolt (M8x40mm)
[6 pieces]
#33 Washer (M8)
[10 pieces]
#40 Nylon Nut (M8)
[8 pieces]
#24 Hex Bolt (M8x105mm)
[2 pieces]
#56 Pop Pin
[2 pieces]
