BRT1875 BRT2885
Page 9
Assembly STEP 3
Hardware Required
Referring to the drawing below, insert the
Axle (#19)
through the
horizontal stems on the
Center Post (#02)
. Then, on the left side of
the
Axle (#19)
-- in the following order, slide on: one
Wavy Washer
(#36)
followed by the
Left Coupler Bar (#05)
, one
D Shape Washer
(#37)
, one
Round Cap (#57)
,
one Washer (#33)
, and secure using
one
Bolt (#26)
.
On the opposite side of the
Axle (#19)
, assemble -- in the following
order: one
Wavy Washer (#36)
followed by the
Right Coupler Bar
(#06)
, one
D Shape Washer (#37)
, one
Round Cap (#57)
, one
Washer (#33)
, and secure using one
Bolt (#26)
.
Attach the
Right Pedal Tube (#04)
onto the
Crank (#20)
as
illustrated and secure by inserting from the outer edge of the
Right
Pedal Tube (#04)
, one
Pedal Hinge Bolt (#31)
and one
Wavy Wash-
er (#35)
. Secure from the inner edge (behind the
Crank(#20)
) with
one
Nylon Nut (#42)
.
*** PLEASE DO NOT tighten the hardware until steps below have
been completed. This will allow you to align the holes for proper
and smooth assembly.***
Repeat this process on the other side using the
Left Pedal Tube
(#03)
. Using the drawings as a reference, attach the free end of the
bottom of the
Right Coupler Bar (#06)
to the front of the
Right Pedal
Tube (#04)
by aligning the holes. After the holes are aligned, insert
one
Bolt (#28)
through the
Right Pedal Tube (#04)
, the
Right Coupler Bar (#06)
and secure using one
Washer (#34)
followed by one
Nylon Nut (#41)
.
Repeat this process on the other side using
Left Coupler Bar (#05)
and
Left Pedal Tube (#03)
.
**NOW, you may tighten the hardware on both sides.***
#36 Wavy Washer
(Ø19mm)
[2 pieces]
#37 D Shape Washer
(19mm)
[2 pieces]
#57Axle Cover
[2 pieces]
#33 Washer (M8)
[2 pieces]
#26 Bolt (M8x20mm)
[2 pieces]
#42 Nylon Nut
(1/2")
[2 pieces]
#41 Nylon Nut
(M10)
[2 pieces]
#34 Washer (M10)
[2 pieces]
#31 Pedal Hinge Bolt (1/2"x97mm)
[2 pieces]
#28 Bolt (M10x58mm)
[2 pieces]
#35 Wavy Washer
(Ø16mm)
[2 pieces]
