BRB3785 BRB2866
Page 8
Assembly STEP 2
TENSION CONTROLLER CABLE & CENTER POST ASSEMBLY
Remove these pre-assembled parts from the
Main Frame (#01)
and
set them aside nearby: four
Bolts (#14)
and four
Arc Washers (#27)
.
With the help of an assistant, connect the wire of
Tension Controller
(#25)
to
Tension Controller Wire (#19)
as shown in exploded diagram
A. Connect
Monitor Wire 1 (#10)
to
Monitor Wire 2 (#11)
as shown
in exploded diagram B. Connect
Hand Pulse Wire 1 (#35)
to the
Hand Pulse Wire 2 (#29)
as shown in exploded diagram C.
Then, being careful to avoid pinching wires by tucking the connected
wires into the hollow tubing, slide
Center Post (#02)
onto the
protruding tube of
Main Frame (#01)
. Secure using the four
Bolts
(#14)
and four
Arc Washers (#27)
that were set aside nearby.
PEDAL ASSEMBLY
Attach the
Pedal Belt (L)
to the
Left Pedal (#31)
and
Pedal Belt (R)
to the
Right Pedal (#28)
as shown in the exploded diagram D.
Screw on the
Right Pedal (#28)
to the
Right Crank (#34)
by turning
the
Right Pedal (#28)
CLOCKWISE.
Repeat on the other side using
Left Pedal (#31)
and turning the left
pedal COUNTER-CLOCKWISE.
Hardware Required
A
B
C
D
#14 Bolt (M8x15mm)
[4 pcs]
#27 Arc Washer (M8)
[4 pcs]
