BCB 810 Mid-Width Bench
Assembly Instructions
Page 5
A. With the help of an assistant, stand the two
Upright
Assemblies
(#01R & #01L)
on a level floor as illustrated.
B. Slide two
Hex Bolts (#22)
through two
Washers (#31)
, one
Reinforcement Plate (#17)
and then through the
Left Upright
Assembly (#01L)
as illustrated. Repeat this step on the
opposite
side.
C. Attach the
Rear Cross Brace (#02)
to the two
Upright Assemblies
(#01L & #01R)
using a total of four
Washers (#31)
and four
Lock Nuts (#30)
. Firmly tighten all nuts and bolts but be careful
not to overtighten them.
A s s e m b l y S t e p 1
Please note: This
diagram is designed to
help you easily identify
the hardware type and
quantity you will need
to complete each step.
#24 Hex
B
olt (M10x60 mm)
#26 Hex
B
olt (M10x50 mm)
#27 Hex
B
olt (M10x25 mm)
#28 Hex
B
olt (M8x15 mm)
Bolts
Nuts
Washers
#22 Hex
B
olt (
M10x80 mm
)
[ 4 Pieces]
#29 Lock
N
ut (
M6
)
#30 Lock
N
ut (
M10
)
[4 Pieces]
#31 Washer (
M10
)
[8 Pieces]
#32 Washer (
M8
)
#23 Hex
B
olt (
M10x85 mm
)
Hardware Required
