1) Release the front sled and pull it al the
way backwards.
2) Place the handlebar on top of the front
sled as shown in figure 5.
3) Screw a 4mm bolt into the sled from be-
low. Remember to use a washer in between
as shown in figure 5. Tighten with no more
than 8 Nm.
HANDLEBAR
Figure 5
A
SSEMBL
Y
BOTTLEHOLDER
PLEASE NOTE
Make sure the
handlebar is stable.
!
1) Grab the bottleholder and install two o-rings on each
side.
2) Press the bottleholder into the steer as shown in figure
6. Make sure that the o-rings stay in place.
WASHER
BOLT 4mm
O-RING
PLEASE NOTE
Do not lift the bike in the bottleholder
!
Bottleholder
011
