5.1
Removing the Finger-Safe Cover –
The Finger-Safe Cover may have to be removed before
wiring the drive or setting selectable jumpers. All trimpots can be readjusted with the Finger-
Safe Cover installed. Notice the orientation of the Finger-Safe Cover before removing it.
Note:
The Finger-Safe Cover is designed with a removable panel (on the trimpots side) which
must be removed for installation of optional accessories SIVFR Signal Isolator and Run/Fault
Relay or Multi-Speed Board. Complete instructions are provided with the accessories.
Models 2982, 2983, 2984,2987 –
To remove the Finger-Safe Cover, gently lift up on the four
retainer clips until the cover disengages from the base. See Figures 2B and 3A, on pages 17
and 18.
5.2
Installing the Finger-Safe Cover –
To install the Finger-Safe Cover, be sure to properly align
the retainer clips or push-ins. Gently push the Finger-Safe Cover onto the base until the
retainer clips or push-ins are fully engaged with the base.
6
SETTING SELECTABLE JUMPERS
The drive has customer selectable jumpers which must be set before the drive can be used. For the
location of jumpers, see Figure 4, on page 20.
23
