7) CONNECTING A DOUBLE FACE CLOCK
- Open up the 2 clocks by unscrewing the 9 screws (R).
- Pass the connector (HE14) through the grommet (S) on each clock, and connect it to the
male connector (T).
Caution :
1 - Cables for respectively the master clock and the slave clock are not the same : there is a
specific mark for each of these.
2 - The cables for the master is one meter long. This cable can not be extended as it may
cause a problem with the clock operation mode.
- Close up the clock again.
- Connect the 115 or 230 V 50/60 Hz mains supply (depending on the model) (cf. Chapter 2)
and whatever the type of master clock, the slave clock wire to the master clock.
7
R
S
T
Slave clock
Female DIN
connector
Male DIN
connector
Mas ter clock
