Böcker Ab 286, Operating Instructions Manual, Page: 29 / 50

Toplift / Toplift ECO
29 92023200095
9.2 Changing the rope
The operational security and the lifetime of the rope
depends on proper use and good maintenance. It is
important to totally unwind the rope regularly and ex-
amine the rope for damage. The rope has to be
regularly cleaned from old grease, dust and corro-
sion and has to be lubricated.
9.3 Checking the rope and discarding
The ends of the rope have to be properly attached.
Upon checks by the competent person the rope has
to be checked for fractures. Damage that is visually
easy to establish are: Kinks, untwisting, crushings,
sharp bends, corrosion, birdcaging, strong reduction
of the rope diameter and breakage of a strand.
Attention! Always wear gloves when re-
placing the rope.
Before fiitting unroll the wire rope completely on the
ground before fitting to the drum to avoid twisting.
9.4 Fitting of the hoisting rope on the
cable drum Toplift 225 Universal /
234 / 240 / Furniture
•
Remove the front wall by loosening the four
hexagon screws.
•
Remove the old cable from the drum winch and
dismantle the cable lock for the new cable.
•
Loosen the hex socket screw (use a 4mm hex
socket wrench) on the left-hand side of the
winch in order to be able to remove the cable
•
Completely unroll the new cable on the floor.
•
Now place the cable onto the drum winch
from the left .
•
The cable is placed onto the cable drum by
three winds and clamped in using the hex
socket screw (use a 4mm hex socket
wrench).
•
Push the button UP and wind the rope on the ca-
ble drum. See to it that the windings lay properly
next to each other
•
Then guide the end of the cable through the roll-
ers of the slack cable safety device and secure
the front wall using the four hexagon screws.