Boca Systems Complete IDE Series, Manual

Page: 25 / 40

25
5.3 Attaching Internal Cables
1. Attach the appropriate cables and secure for the following
connectors:
Drive Activity LED J5 Serial B Connector J3 (if used)
2. Attach one end of the 40-pin cable to the hard disk drive in the
system and the other end to the J1 connector on the IDE controller.
Make sure Pin 1 on the cable is mated to Pin 1 on the IDE200 and on
your hard drive. Don’t forget to connect the hard drive to the
system’s power supply. If connecting and configuring a second hard
drive, refer to your drive manufacturer ’s documentation.
3. Attach one end of the 34-pin cable to the floppy drive in the system
and the other end to the J2 connector on the IDE controller.
NOTE: When connecting cables, be sure that Pin 1 on the cable, usually
marked with a colored stripe (often red), matches up with pin 1 on the board
connector.
Physical Installation