bObsweep bObi Pet 2015, Owner'S Manual, Page: 51 / 66

If you notice that bObi is not working in her usual way or repeatedly runs into a cer-
tain error, you may want to perform a checkup test to find out what is causing the
issue. bObi’s remote can be used to test all of her sensors and electronic parts in
the span of a few minutes. If bObi does not produce the results as described during
any of her tests, contact our support team for further assistance.
To begin the checkup, make sure the side power button on bObi is turned OFF.
Bring bObi near the remote.
Put bObi in checkup mode
Press and hold the OK button on the remote while you switch bObi’s power back ON.
Continue holding the OK button. The three touch buttons (GO!, WAFFLE, JUICE) on
bObi’s cover will start flashing. While the touch buttons are flashing, simultaneously
press the WAFFLE and JUICE buttons on bObi’s cover with the OK button on the
remote still held down. When bObi makes two beeping sounds, release the OK but-
ton and you will notice that all the digits on her remote become zeroes. bObi is now
in test mode. While in this mode, the three buttons on bObi’s cover (GO!, WAFFLE,
JUICE) stay on, and the 5 LED lights above the buttons flash sequentially.
You may switch between different tests by pushing the LEFT button on the remote.
Alternate between different parts of a certain test by pushing the RIGHT button,
which will change the digits to let you know what part of bObi is being tested.