The 4 bars above the word “checkup” should be
lit. Lift Bob about 6 inches (15 cm) off the ground
and the 4 bars should turn off.
Step 1:
Edge Sensors
Drag a thick, flat, and light-colored surface
around Bob’s bumper.
The 5 bars below the word “checkup” should
light up one at a time as you move your surface
from the left side of Bob’s bumper around to the
right side.
The far right sensor is less sensitive than the
others, so it may not respond the first few passes.
Step 2:
Obstacle / Wall Sensors
Step 3:
Touch Sensors
Press the
GO!
button on Bob’s cover.
The charging station must be synced and
plugged in for this step.
Place Bob about 1 foot (30 cm) away from the
charging station, with his front facing the red
light on the station. Keep blOck Plus™ away
from Bob so its signal does not interfere with
the test. The words “deep clean,” “quick clean,”
and “touch up” should be lit on Bob’s screen.
Step 4:
Charging Station
Quick Start
Home
Checkup
Test
Home Checkup Test: Steps 1 to 4
check up
charging
Oops! I feel there’s something funny
going on with my:
Edge Sensors
Touch Sensors
Left Wheel
Main Brush
Obstacle Sensors
Dustbin
Right Wheel
Power System
cleaning
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
check up
charging
Oops! I feel there’s something funny
going on with my:
Edge Sensors
Touch Sensors
Left Wheel
Main Brush
Obstacle Sensors
Dustbin
Right Wheel
Power System
cleaning
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
check up
charging
Oops! I feel there’s something funny
going on with my:
Edge Sensors
Touch Sensors
Left Wheel
Main Brush
Obstacle Sensors
Dustbin
Right Wheel
Power System
cleaning
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
Press the left side of Bob’s bumper, and the bar
to the left of the word “checkup” should light up;
press the right side of the bumper, and the bar to
the right of the word “checkup” should light up.
Press the center of the bumper, and both bars on
either side of the word “checkup” should light up
at the same time.
When you release the bumper, the bars should
turn off.
check up
charging
Oops! I feel there’s something funny
going on with my:
Edge Sensors
Touch Sensors
Left Wheel
Main Brush
Obstacle Sensors
Dustbin
Right Wheel
Power System
cleaning
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
check up
charging
Oops! I feel there’s something funny
going on with my:
Edge Sensors
Touch Sensors
Left Wheel
Main Brush
Obstacle Sensors
Dustbin
Right Wheel
Power System
cleaning
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
To skip ahead in the checkup test, follow the
button sequence (bolded in blue).
To exit the checkup test, flip Bob’s power switch
OFF and then ON.
!
The words “deep clean” and “touch up” represent the charging station’s sensors. If either one of them
fails to light up on Bob’s screen, then there is likely something wrong with Bob’s station. The word
“quick clean” represents the signal on Bob’s bumper. If it fails to light up, then Bob likely needs a new
bumper transmitter.
Quick Tip:
100
99