WARNING: TURN ELECTRICAL POWER SUPPLY OFF
BEFORE MAKING ELECTRICAL CONNECTIONS. DRYER
MUST BE GROUNDED (EARTHED).
Finish Face of Floor
10-15/64''
260mm
S
S
33/64''
13mm
7-43/64''
195mm
Dimension
A
1-7/64''
28mm
S
9-7/16''
240mm
5/16''
8mm
3/4''
19mm
15/32''
12mm
10-3/8''
265mm
8-43/64''
220mm
3/16''
5mm
3/4''
19mm
6-1/16''
155mm
S
1''
25mm
1-3/8''
35mm
Flange Cutout for
Surface Wiring
7/8''
22mm
Dia. Hole for
Between Wall Wiring
BOBRICK
BOBRICK
Form No. 700-69 Multi Language (Rev. 7/1/13) © 2013 Bobrick Washroom Equipment, Inc. Printed in U.S.A.
Electrical Characteristics
Recommended Mounting Heights
Removal of Cover
Installation of Mounting Base
Important
2
Hand dryer models B-700, B-708, 115V AC, 20 Amp, 50/60 Hz, Single Phase, cULus listed;
Hand dryer models B-700, B-708, 208-240V AC, 9-10 Amp, 50/60 Hz, Single Phase, cULus listed, VDE approved, CE marked.
Hand dryer models B-770, B-778, 115V AC, 12 Amp, 50/60 Hz, Single Phase, cULus listed;
Hand dryer models B-770, B-778 208-240V AC, 5.5-6.3 Amp, 50/60 Hz, Single Phase; cULus listed, VDE approved, CE marked.
Distance from floor to bottom mounting screw holes of mounting base. (Dimension A)
1. Start installation of dryer by
removing cover. To loosen
two cover bolts, insert Allen
Wrench (provided with dryer)
into holes located on bottom
of cover on each side of air
intake grille. Make sure
wrench fits into head
of cover bolts and turn
CLoCkWiSE until bolts stop
turning. When cover bolts
are screwed in all the way,
cover can be removed.
2. To remove cover, place a
hand on each side of cover
and push up toward top
of dryer releasing cover
from studs at top of
mounting base. Lift cover
off mounting base by
pulling forward at the
bottom and upward at the
same time.
Hand Dryer
*
Bobrick automatic hand dryers should be installed 15" (380mm) above any projection or horizontal surface which may interfere with
the operation of the automatic sensor.
1. Hold the installation Template against the wall in the desired
location of the installed dryer. See recommended mounting
heights above.
2. Make sure line on template representing bottom of dryer
mounting base is horizontal and located at the desired height
above floor.
NOTE:
Surface-mounted electrical supply entry is located in the
lower right corner of the mounting base. Surface-mounted supply
cable should be fitted in a conduit.
3. Drill four holes for 1/4" (6.4mm) diameter mounting bolts or
screws (not furnished by Bobrick).
4. Fasten mounting base securely to wall.
Men's Washrooms .............................................................................................................................................................46'' (117cm)
Women's Washrooms ........................................................................................................................................................44'' (112cm)
Children's Washrooms, ages 3-9 ......................................................................................................................................32'' (81cm)
Children's Washrooms, ages 9-12 .....................................................................................................................................36'' (91cm)
Children's Washrooms, ages 12-15 ...................................................................................................................................40'' (102cm)
Children's Washrooms, ages 15-18 ...................................................................................................................................44'' (112cm)
For the Handicapped .........................................................................................................................................................38'' (97cm)
*
Warm air hand dryer. Intended for use in a household environment by non-expert users. Not suitable for outdoor use.
**
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
***
If a fault develops disconnect the electrical supply, a qualified electrician should be called.
FOR PROPER ELECTRICAL CONNECTIONS, CHECK LOCAL
BUILDING CODE. UNIT MUST BE INSTALLED BY
A QUALIFIED LICENSED ELECTRICIAN
