Attaching the Steam Head
Attaching the Steam Head
●Slide the bottom end of main
body C onto.tvhe steam head
E until steam head spindle 9
Clicks into place.
●The Steam head E can be
removed from the Main body
C by pressing salient point on
the Steam head E spindle.
Attaching a Cleaning Pad
●Because of barb design at
the bottom of steam head C,
just place a micro-fiber clean-
ing pad F to steam head, they
can bond hard.
●Place the front of your shoe
onto the cleaning pad remov
-
al Tab and press down firmly.
Operation
1. Filling the water tank.
Method one
：
Open the water tank cup 5, fill
370 ml water use measuring
cup,And then to close water
tank cup 5
Method two
：
●Remove the water tank from
main body,
，
open the Water
tank cup 5, fill The water tank
from water faucet and then to
close water tank cup 5;
●Install the water tank5 to main
body C until it clicks into
place.a
2. Plug in the appliance to a grounded outlet.
3. When switch the appliance on,the indicator lights will turn red,it indicate
preheating.If the lights does not illuminate,please check the "troubleshooting"
section for more details
.
4. The product cold warm-up time of 30 seconds, after the completion of the
preheat indicator color conversion is blue, the product began to work.
NOTICE: If power failure in the middle of the warm-up or power-off after the warm-up is
complete, turn the power supply on again, according to the interval of the power is turned
on again, the product may repeat the above warm-up operation.
5. When normal cleaning,the steam head has big rotary angle,can clean
corners and also can clean low space.
Cleaning and Maintenance
Be sure that the unit is disconnected from the rower outlet when performing cleaning
.
Drain the remaining water in the tank and clean the tank after every use.
How to decalcify the Water Tank interior
To clean calcium deposits that build up inside the Water Tank , add one or two
tablespoons of white vinegar to a full Water Tank close the Water Tank Cap
and then shake the contents.
Do Not Turn The Steamer On.
Cleaning procedure to remove lime scale
If your steam mop begins to produce steam more slowly than usual or stops
producing steam , you may need to remove lime scale. Lime scale can devel
-
op over time on the metal parts and greatly affect mop performance.
It is necessary to remove lime scale on regular basis every 25-50 times you use
a full tank of water or at least once a month, especially in areas with hard
water.
The frequency of lime scale removal depends upon the hardness of you tap
water and how often you use the steam mop.
5
6
Cleaning and Maintenance
