assembly
&
disassembly
13
1
2
3
4
6
5
7
8
9
10
11
12
13a
13b
7. lift out board and carefully remove
from frame
8. unscrew FRONT trigger frame retaining
screw until there is a slight gap between
the body and frame - see
HOT TIPS
below
9. unscrew REAR trigger frame retaining
screw until there is a slight gap between
the body and frame - see
HOT TIPS
below
10. slide frame gently towards rear of marker
body and remove frame from body
11. remove trigger retaining screw
12. remove trigger by sliding up through
top of frame
13a. remove trigger spring bracket
retaining screws
[
2
]
13b. trigger spring bracket removed
HOT TIPS
To re-install trigger frame, be sure both Trigger
Frame Screws are slightly threaded into the body.
Hold in Trigger while aligning the frame and gently
slide frame forward into position and then
tighten screws in unison.
If only one screw is fully tightened, the frame will
not properly mount onto the body. You must
turn in one screw a few turns and then do the
same on the other. Repeat until the frame is
properly mounted to the Marker Body.
14
2.TRIGGER FRAME
DISASSEMBLY
1. remove high-pressure regulator
2. remove asa retaining screws
[
2
]
using a 1/8
”
allen key and remove asa
3. remove left rubber grip panel
4. remove battery
5. using an allen key or small screw
driver, carefully disconnect
wiring harness
6. remove board retaining screw
HOT TIPS
Always inspect the Frame
’
s internal
components to ensure no damage is
present. If a part is damaged it should
be replaced to ensure Marker does not
fail during normal operation.
When re-connecting wiring harness to
Board, DO NOT apply excessive pressure.
The Harness should connect with relative
ease using minimal pressure.
Always inspect Rubber On/Off Button to
to ensure it is still firmly secured to the
rear of the Trigger Frame.
