12
EN
Optional Float Installation
1. Remove all 4 screws and the cover plates
from the bottom of the fuselage. Keep these
materials to reuse in step 4.
2. Carefully remove and retain the landing
gear from the fuselage.
3. Push the square loops of the front and rear
float struts into the slots in the bottom of the
fuselage.
4. Reuse the 4 screws and 2 cover plates from
step 1 on the front of the aircraft, then use
the 4 screws and 2 cover plates that are
included with the float set on the rear section
to complete the installation.
CAUTION:
Never go alone to get a downed
aircraft in the water.
CAUTION:
If at any time water splashes in
the fuselage while fl ying from water, bring the
aircraft to shore, open the battery hatch and
immediately remove any water that may have
gotten in the fuselage. Leave the battery hatch
open overnight to let the inside dry out and to
prevent moisture damage to the electronic
components. Failure to do so could cause the
electronic components to fail, which could result in
a crash.
