~ Page | 6 ~
BNCE-30_Operations_Manual.indd
May 13, 2019
Remove Hazardous Substances
Since the tool is an electric tool, it may spark and
cause an explosion or a fire if operated near gas
cylinders, thinner, or explosive and other hazardous
substances or in a place filled with flammable gas,
etc. Therefore, do not use the tool in places where
such hazardous substances are present.
! DANGER
May cause an explosion
or a fire. Ignoring this warning may
cause death or serious injury. Never
use the tool in places filled with
flammable gas or near hazardous
substances of high flammability.
Maintenance of the Main Unit
Always unplug the saw from the electric outlet be-
fore attempting any maintenance. Clean the entire
unit occasionally by removing dust, debris and oils.
Occasionally remove the flush cutting bottom plate;
then remove any cutting chips that remain lodged in
the area where the cutting blade rotates.
It is also recommended that the cutting blade be re-
moved and inspect for any materials that did not exit
out the chip exhaust area. This should be done after
4-8 hours of use. Most material cutting chips would
normally exit out the chip exhaust area and into the
Cutting Chip Catch Bag. It is recommended that the
Cutting Chip Catch bag be emptied when it becomes
2/3 full of cut material.
RB-BNCE-30 Blade
The Blade for the BNCE-30 Cutting Edge Saw™
should be replaced when the blade is dull or
chipped and a noticeable increase in cutting time
has occurred.
To change the Blade, remove the screws that hold
the Blade Cover to the Body (4). Remove the cover
and unscrew the (4) bolts holding the blade to the
Hub. The replacement blades that you purchase
have new screws to be used when installing the new
blade. Make sure that when you remove the blade
you clean out the head of any metal debris that has
not escaped the tool.
Please see your distributor or call BN Products-USA,
LLC at the number above or visit us on the web
www.bnproducts.com for more information.
General Operating Cautions
The following describe the general cautions on
operating tool. Always observe the cautions stated
in each item.
• Do not press the operation switch if the tool is
pointed towards anyone. Operating the tool by
holding it toward anyone may cause injury from
contact with the blade.
• Do not apply the Cutting Edge Saw for purposes
it is not intended.
• Do not use the tool for lifting or hammering etc.
instead, only use this tool for cutting. Other-
wise, the main unit may be broken or damaged,
causing injury.
Model No.
BNCE-30
Power Supply
120 Volt -60 Hz, 9 Amp, Single
phase
Motor Type
1100 Watt Double Insulated
No-Load
Blade Speed
2,000 RPM
Max Cutting
Capacity
1” (25mm)
Max Blade
Diameter
5” (127 mm)
