~ Page | 5 ~
BNCE-30_Operations_Manual.indd
May 13, 2019
however the primary design was for flush cutting or
free cutting reinforcing bars, coil rod and all-thread-
ed rod used in the construction industry.
Application of the Tool - Actual areas of application
the Cutting Edge Saw is used for are as follows:
BNCE-30
3/8” to 1“ or 10mm to 25mm grade 60 rebar (re-
inforcing bars), up to ½” I.D. pipe, 1” O.D. copper
water pipe, 1” O.D. tubing, 1” conduit, 1” square
steel tubing and bar, and up to 1” O.D. all-threaded
or coil rod.
Rules of Use and Storage - To use the tool to its
fullest performance, the user is required to be fully
familiar with the saw itself, the cutting blades, and
storage procedures upon completion of work.
Specifications
The power tool is a multipurpose saw with an
enclosed guard and flush cutting capabilities. The
specifications of the main unit are as follows.
Standard Blade: (Best for Ferrous Metals)
The BNCE-30 is supplied with (2) each 5” (127mm)
blade diameter × 1.6mm thickness, 24 teeth with
laser welded flange for mounting to Cutting Edge
Saw spindle. The maximum blade RPM is 2,000.
Operation
Checking and Preparation of Working Environment:
Check the following before using the Cutting Edge
Saw. Always observe the instructions and prohibited
items.
Checking of weather conditions, do not use in the
rain or snow:
! DANGER: The Cutting Edge Saw is
not a waterproof power tool. If it
becomes wet, the power source
system may become faulty or the
operator may get an electric shock. Therefore, when it
is raining or snowing, never operate this saw outdoors,
on top of buildings or under roofs where rain or snow
enters freely. Do not use where water accumulates or
where water splashes.
Operation Instructions
Adjust the rear handle position to comfortably grip the
tool. (The rear handle changes position with the but-
ton located on the top of the handle.) Locate the front
handle in the mounting hole that provides the best grip.
To operate the trigger, depress the trigger lock button
(on the side of the tool) and then pull the trigger to start
the saw. Start the saw before cutting and then apply a
light pressure moving forward through the cut.
! DANGER: Electric Shock Hazard.
Ignoring this warning may lead to death
or serious injury. When raining or
snowing, do not operate outdoors or
indoors where rain or snow enters freely
or in extreme temperatures.
Do not use under high temperature and humidity or
extremely cold temperature conditions. The tool is de-
signed for use under an allowable environmental tem-
perature of 0 to 100°F. Operation at higher temperature
may cause the tool’s main unit to overheat. Operation
at high temperature with high humidity may cause the
tool to fail due to condensation.
Also, do not operate the Cutting Edge Saw in very cold
places or inside refrigerators where the temperature is
freezing or below.
Check The State of Your Work Site
Before using the tool, check whether the state of the
worksite is as follows; is the worksite free of foreign ob-
jects, debris, water, ice, snow, powered electrical cables,
and excessive dust? Is the floor free of obstructions? Is
there adequate ventilation? Is the worker properly in-
sulated from the ground. Follow the operation instruc-
tions and avoid prohibited items.
