Page | 6
Op e ra tio n In s tru ctio n s
Locate the front handle in the m ounting hole that provides the best grip. To operate the
trigger, depress the trigger and slide forward to start the saw. Start the saw before cutting
and then apply a light pressure m oving forward through the cut.
! DANGER: Electric Shock Hazard. Ignoring this warning m ay lead to
death or serious injury. When raining or snowing, do not operate
outdoors or indoors where rain or snow enters freely or in extrem e
tem peratures.
Do not use under high tem perature and hum idity or extrem ely cold
tem perature conditions. The tool is designed for use under an allowable
environm ental tem perature of 0 to 120 °F.Operation at higher tem perature m ay cause the
tool’s main unit to overheat. Operation at high temperature with high humidity may cause
the tool to fail due to condensation.
Also, do not operate the Cutting Edge Saw™ in very cold places or inside refrigerators
where the tem perature is freezing or below.
Check The State of Your Work Site.
Before using the tool, check whether the state of the work site is as follows. Is the worksite
free of foreign objects, debris, water, ice, snow, powered electrical cables, and excessive
dust? Is the floor free of obstructions? Is their adequate ventilation? Is the worker prop
-
erly insulated from the ground. Follow the operation instructions and avoid prohibited
item s.
Rem ove Hazardous Substances.
Since the tool is battery operated, it may spark and cause an explosion or a fire if operated
near gas cylinders, thinner, or explosive substances or in a place filled with flammable gas,
etc. Therefore, do not use the tool in places where such hazardous substances are present.
Ignoring this warning may cause death or serious injury. Never use the tool in places filled
with flammable gas or near hazardous substances of high flammability.
Ma in te n a n ce o f th e Ma in U n it
Clean the entire unit occasionally by rem oving dust, debris and oils. Occasionally rem ove
the flush cutting bottom plate; then remove any cutting chips that remain lodged in the
area of the cutting blade.
Summary of Contents for BNCE-30-24V
Page 12: ...Page 12...
Page 13: ...Page 13...
