BMW X1 2018, Owner'S Manual

Page: 208 / 314

3. As soon as the interior mirror LED starts
flashing slowly, hold the hand-held transmit‐
ter for the system to be controlled approx. 1
to 3 inches/2.5 to 8 cm away from the but‐
tons of the interior mirror. The required dis‐
tance depends on the hand-held transmitter.
4. Likewise, press and hold the button of the
desired function on the hand-held transmit‐
ter.
5. Release both buttons as soon as the interior
mirror LED flashes more rapidly. The LED
flashing faster indicates that the button on
the interior mirror has been programmed.
The system can then be controlled by the
button on the interior mirror.
If the LED does not flash faster after at most
60 seconds, change the distance and repeat
the programming starting with step 4. Several
more attempts at different distances may be
necessary. Wait at least 15 seconds between
attempts.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the in‐
terior mirror button and repeatedly press and
release the hand-held transmitter button for
2 seconds.
Operation
WARNING
Body parts can be jammed when operating re‐
mote-controlled systems, such as the garage
door, using the integrated Universal Remote
Control. There is a risk of injury or risk of dam‐
age to property. Make sure that the area of
movement of the respective system is clear
during programming and operation. Also follow
the safety information of the hand-held trans‐
mitter.
The system, such as the garage door, can be op‐
erated using the button on the interior mirror
while the engine is running or when the ignition
is started. To do this, hold down the button
within receiving range of the system until the
function is activated. The interior mirror LED
stays lit while the wireless signal is being trans‐
mitted.
Deleting stored functions
All stored functions will be deleted. The func‐
tions cannot be deleted individually. Press and
hold the two outer buttons on the interior mirror
simultaneously for approximately 20 seconds un‐
til the LED on the interior mirror flashes rapidly.
Digital compass
Overview
1 Control button
2 Mirror display
Mirror display
The point of the compass is displayed in the mir‐
ror when driving straight.
Operating concept
Various functions can be called up by pressing
the control button with a pointed object, such as
the tip of a ballpoint pen or similar object. The
following setting options are displayed in succes‐
sion, depending on how long the control button
is pressed:
▷ Pressed briefly: turns display on/off.
▷ 3 to 6 seconds: compass zone setting.
▷ 6 to 9 seconds: compass calibration.
Seite 208
CONTROLS
Interior equipment
208
Online Edition for Part no. 01402120596 - II/18