BMW X1 2018, Owner'S Manual

Page: 207 / 314

Programming
General information
1. Switch on the ignition.
2. Initial setup:
Press and hold the two outer buttons on the
interior mirror simultaneously for approxi‐
mately 20 seconds until the LED on the inte‐
rior mirror flashes. This erases all program‐
ming of the buttons on the interior mirror.
3. Hold the hand-held transmitter for the system
to be controlled approx. 1 to 3 inches/2.5 to
8 cm away from the buttons of the interior
mirror. The required distance depends on the
hand-held transmitter.
4. Simultaneously press and hold the button of
the desired function on the hand-held trans‐
mitter and the button to be programmed on
the interior mirror. The LED on the interior
mirror will begin flashing slowly.
5. Release both buttons as soon as the LED
flashes more rapidly. The LED flashing faster
indicates that the button on the interior mirror
has been programmed.
If the LED does not flash faster after at least
60 seconds, change the distance between
the interior mirror and the hand-held trans‐
mitter and repeat the step. Several more at‐
tempts at different distances may be neces‐
sary. Wait at least 15 seconds between
attempts.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the in‐
terior mirror button and repeatedly press and
release the hand-held transmitter button for
2 seconds.
6. To program other functions on other buttons,
repeat steps 3 to 5.
The systems can be controlled using the interior
mirror buttons.
Special feature of the rolling code
wireless system
If you are unable to operate the system after re‐
peated programming, please check if the system
to be controlled features a rolling code radio sys‐
tem.
Read the system's owner's manual, or press the
programmed button on the interior mirror longer.
If the LED on the interior mirror starts flashing
rapidly and then stays lit constantly for 2 sec‐
onds, the system features a rolling code radio
system. Flashing and continuous illumination of
the LED will repeat for approximately 20 sec‐
onds.
For systems with a rolling code radio system, the
integrated Universal Remote Control and the
system also have to be synchronized.
Please read the owner's manual to find out how
to synchronize the system.
Synchronizing is easier with the aid of a second
person.
Synchronizing the universal remote control with
the system:
1. Park the vehicle within range of the remote-
controlled system.
2. Program the desired button on the interior
mirror as described.
3. Locate and press the synchronizing button
on the system being programmed. You have
approx. 30 seconds for the next step.
4. Hold down the programmed button on the in‐
terior mirror for approximately 3 seconds and
then release it. If necessary, repeat this step
up to three times in order to finish synchroni‐
zation. Once synchronization is complete, the
programmed function will be carried out.
Reprogramming individual
buttons
1. Switch on the ignition.
2. Press and hold the interior mirror button to be
programmed.
Seite 207
Interior equipment
CONTROLS
207
Online Edition for Part no. 01402120596 - II/18