3.2.7
Cut-in the ignition switch by use of key (turn the key counterclockwise for
daytime driving and vice versa).
3.2.8
Press down the kickstarter slightly by foot to make the brake block insert into
the ratchet wheel of the starting gear (No idle travel is felt). Then starting can be
realized by stepping the kickstarter forcefully. If staring motor is used, first set the
levers to neutral positon. (see Figs 4 and 5),or hold the clutch lever with left hand to
disengage the clutch. Press the starting button with right hand (each press should not
take more than 3 seconds. Interval between two presses should not be less than 2
seconds. Restarting should be done one minute later after three successive presses).
Caution
: If it fails to start by trying several times, it is forbidden to
successs-vely press the starting button or step the kickstarter. Otherwise it
will shorten the life of battery and starting mechanism.
3.2.9
After the engine is started, slowly open the air valve according to the engine
operating condition.
3.2.10
According to the operation sound of the engine, rotate the throttle grip to
warm up the engine at low speed and then drive the motorcycycle.
3.3 Astern driving of three-wheel motorcycle (with sidecar)
For astern driving operate as follows:
a. Stop the motorcycle.
b. Set the gear to position No. 1 (or neutral)
c. Apply the astern lever with teft tiptoe or left sole
to Astern position.
d. Drive astern the motorcycle with normal driving
method
Astern operation Positions are shown in Fig 6
3.4 Engine Shutdown
3.4.1
For engine shutdown, reduce the throttle, then
turn off the ignition switch.
3.4.2
After engine shutdown, take out the key and
set the gasoline control knob to OFF positicn. For long
period parking, the battery should be disconnected to
avoid electric leakage.
3.5 Parking in Severe Cold Season
I
n severe cold season, the following procedures
should be taken for parking the motorcycle outside.
