When it is pressed down, the horn operates and when it is released, the horn stops
operating.
5.2.2.4
Turn light switch-when it is turned to left, left turn light comes on and to
rights, right turn light comes on.
5.2.3
Electric starting pushbutton -press down this button is to conduct electric
starting. Attention should be paid not to making continous starting for over 3 seconds,
otherwise the battery may be damaged.
5.3 Battery Servicing
T
he battery used on CJ-750 engine powered motorcycle is lead acid battery 3-M-14,
whose voltage is 6V. The one used on CJ-750D engine powered motorcycle is dry
storage battery 6-MA-28 whose voltage is 12 V.
5.3.1
Make up electrolyte with relative density of 1.28+/-0.01g/cm3 ( measured at 15 )
by mixing distilled water or purified water with pure battery sulphuric acid.
5.3.2
Clean battery surface, take off electrolyte filling cap, make air vent unblocked
and pure the ready-made electrolyte into the battery to a level of 5-10mm above the
plate.
5.3.3
The dry storage battery 6-MA-28, after being charged with electrolyte, should
be put at a standstill for 20 min. before operation. The exterior of the battery should
be cleaned with water and electrolyte filling cap tightened before operation.
5.3.4
The lead acid battery 3-M-14 should be precharged for 3-5 hours after filling
electrolyte. The current for the first phase of precharging is 0.8A. The current can be
changed to 0.4 A when voltage of each cell reaches to 2.4V. The charging can be
stopped when charging voltag and electrolyte relative density keep unchanged for 3
hours.
5.3.5
In charging the positive pole of the battery should be connected to positive pole
of DC power source and the battery negative pole to negative pole of DC source. At the
same time, electrolyte filling cap should be removed to let gas escape. The charging
should not be done near tinder to avoid causing explosion. If temperature of
electrolyte exceeds 45, the battery should be cooled and then charged again.
5.3.6
If it is found that the electrolyte level is lower than plate in charging or using of
battery, distilled water or purified water should be added.
5.3.7
On completion of charging, tighten the electrolyte filling cap and clean exterior
of the battery with water.
