BMW R nineT 2019, Rider'S Manual, Page: 51 / 206

Anti-theft alarm (DWA)
with anti-theft alarm (DWA) OE
DWA activating
Switching on ignition ( 38).
DWA adjusting ( 50).
Switch off the ignition.
If the DWA is activated, the
DWA is automatically activated
after having switched off the
ignition.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm (DWA) is act-
ive.
Alarm signal
A DWA alarm can be triggered
by:
motion sensor
an attempt to use an unauthor-
ised vehicle key to switch on
the ignition.
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash).
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
The alarm signal continues for
approx. 26 seconds. While a
DWA alarm is in progress an
alarm tone sounds and the turn
indicators flash. The type of
alarm tone can be set by an au-
thorised BMW Motorrad dealer.
If a DWA alarm was triggered
while the motorcycle was un-
attended, the rider is notified
accordingly by an alarm tone
sounding once when the ignition
is switched on. The DWA LED
then indicates the reason for the
DWA alarm for one minute.
Light signals issued by the
DWA LED:
Flashes 1x: motion sensor 1
Flashes 2x: motion sensor 2
Flashes 3x: ignition switched
on with unauthorised vehicle
key
Flashes 4x: disconnection of
the DWA anti-theft alarm from
the motorcycle's battery
Flashes 5x: motion sensor 3
4
49
z Operation