BMW R 1200RT 2016, Rider'S Manual

Page: 99 / 229

The gears are shifted into as
usual with foot force on the
shift lever.
The sensor
1 on the gear-lever
shaft detects the intention to
change gear and initiates gear-
shift assistance.
When driving at constant
speed in low gears at high
revs, changing gear without
using the clutch can result in
major load change reactions.
BMW Motorrad recommends
only changing gear using the
clutch in such situations. The
shifting assistant should not
be used in the area of the rev-
limiter.
No shifting support is provided
in the following situations:
With the clutch operated.
If the gearshift lever is not in
the initial position.
When shifting up with the
throttle valve closed (coasting
overrun mode) or when
decelerating.
To be able to make another
gear shift using gear-shift as-
sistance, the gear lever must
be fully released after the first
gear change.
Brakes
How do you achieve
the shortest stopping
distances?
The dynamic load distribution be-
tween the front and rear wheel
changes during braking. The
heavier you brake, the greater
the weight transfer to the front
wheel. Increases in the load at
an individual wheel are accom-
panied by a rise in the effective
braking force that the wheel can
provide.
To achieve the shortest possible
braking distance, the front brake
must be applied quickly and with
increasing force. This procedure
provides ideal exploitation of the
extra weight transfer to the front
wheel. The clutch should also be
disengaged at the same time.
With the extreme emergency
braking technique that motor-
cyclists are often trained to use,
whereby maximum braking force
is applied as rapidly and as pow-
erfully as possible, the dynamic
weight transfer cannot keep up
with the increase in the deceler-
ation rate so that the full braking
force cannot be transferred to
the road surface.
6
97
z Riding
ProCarManuals.com