BMW R 1200 R 2008, Rider'S Manual

Page: 122 / 162

ly flat. Attempting to charge a
completely flat battery via the on-
board socket can cause damage
to the motorcycle's electronics.
Always charge a completely
drained battery directly at the
terminals of the disconnected
battery.
Charge disconnected battery
via onboard socket.
Comply with operating instruc-
tions of charger.
The motorcycle's onboard
electronics know when the
battery is fully charged. The
onboard socket is switched off
when this happens.
Charging disconnected
battery
Charge battery using a suitable
charger.
Comply with operating instruc-
tions of charger.
Once the battery is fully
charged, disconnect the
charger's terminal clips from
the battery terminals.
In the case of longer peri-
ods when the motorcycle is
not being used, the battery must
be recharged regularly. See the
instructions for caring for your
battery. Always fully recharge
the battery before returning it to
use.
Removing battery
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Make sure that the motorcycle is
steady on its stand.
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Removing seat (
60)
An incorrect disconnection
sequence increase the risk
of short-circuiting.
Always observe the proper
sequence.
Remove battery ground wire 2
first.
Then pull off protective cap
1
and remove positive cable.
8
120
z Maint
e
nance
ProCarManuals.com