BMW F 800 GT 2015, Rider'S Manual

Page: 67 / 171

LED flashes for ten seconds.
As soon as the LED goes out,
release button
1 and button 2 .
LED lights up.
Press button
1 or button 2 .
LED goes out.
Remote control is synchro-
nized.
Battery
with anti-theft alarm
OE
When is a battery change
required?
The batteries of the remote con-
trol must be replaced after ap-
prox. 2 - 3 years. A weak battery
can be recognized from the fact
that the LED does not light up at
all or only briefly when a button is
pressed.
Replace battery
Remove screw 1 and take off
lower housing section 2 .
Slide old battery 3 forward un-
der bow 4 .
Batteries of the wrong type
or incorrect poling of the
batteries can destroy the device.
Use specified battery (see the
chapter "Technical Data"). En-
sure proper poling when inserting
the battery.
Install a new battery while mak-
ing sure that positive terminal
of battery is at top.
Position lower housing section
on nose
5 of front edge and
close while watching two guide
pins
6 .
Install screw.
The LED of the remote control
lights up; i.e. the remote con-
trol must be activated.
To activate the remote control
within the range of the receiver,
press the button
1 twice.
LED 2 begins to flash and
goes out after a few seconds.
The remote-control is again
ready to be used.
5
65
z Alarm system
ProCarManuals.com