11
D.
Installation of Voice Input Jumper
1.
If a Voice Input Jumper Plug is not installed then a
Jumper Plug, P/N 84 11 0 018 038, must be
obtained and installed for the system to function
correctly. The jumper plug should be installed
onto a blue 26 pin connector that is located near
the black 54 pin connector for the ULF module.
Note: The Jumper plug is not included in the kit
as this plug may already be installed on some
vehicles.
Reconnect the Battery
E.
Coding ULF Control Module to Vehicle
After installing the ULF Kit, the vehicle should be re-coded with DISPlus/GT1 SW 33 or higher, using the
“Retrofit” path to ensure that the system works properly with the systems currently installed in the
vehicle. The recoding is done automatically when using the following “retrofit” procedure:
•
Connect DIS or GT1 to vehicle (with SW 33 or higher installed)
•
Turn on ignition
•
Select “Coding ZCS”
•
Series: “E39 Series”
•
Path: “2 Retrofit”
•
System: “ULF Universal charging and Handsfree facility”.
•
Follow the on screen requests to activate the coding procedure.
F.
Function test
Upon completion of the recoding, verify that the BMW Universal BluetoothTM Hands-Free System is
working correctly by going through the following action steps. After completing each step ensure that
the desired result is obtained:
Action Response
Pair phone to vehicle (refer to section for
pairing instructions).
Phone and or Radio/MID/Board Computer
should display statement indicating Pairing
succeeded
Turn on radio and initiate a call using voice
recognition commands by
depressing/holding the Voice recognition
button on steering wheel until an audible
beep is heard
Radio should mute and an audible beep is
heard through vehicle speakers.
Say “Dial number”
System states “Please speak the number”
Say phone number to be dialed
ex”1234567890”
System states “1234567890”
If number is correct say “Dial”
Call is placed and number being dialed is
displayed on phone as well as on
Radio/MID/Board Computer.