EN/17
Retrofit / Installation kit No. 82 82 0 304 134 (others see cover sheet)
Installation Instructions No. 01 29 0 141 494
Issue date: 05.2003
8.
To install and route the power supply cable
0
0
0
0
0
Direction of arrow = Driving direction.
Use textile adhesive tape (30) to attach the branch
A1
of the power supply cable
A
,
to the roof hoop
(4/5), as shown in the figure (excess length about
200 mm).
Then route the power supply cable
A
with
branches
A2
to
A6
into the boot on the left.
Only for cars with an alarm system
Use textile adhesive tape (30) to attach the
connection cable (31) for the ultrasonic module.
0
Route the power supply cable
A
along the
standard wiring harness to the retrofit plug
connector
X322
in the boot on the left and use
textile adhesive tape (30) or the cable ties already
in the vehicle to attach it.
0
Disconnect retrofit plug connector
X322
.
Unlock the white 12-pin socket casting (30) of the
retrofit plug connector
X322
.
Disconnect the socket casing slot
PIN1
, red/green
cable.
Connect the socket contact of the branch
A2
, red/
green cable, into the empty slot
PIN1
of the 12-pin socket casing (30).
Connect the disconnected socket contact, red/
green cable, into the black socket casing (16).
Connect the black socket casing (16) to the plug
casing of the branch
A2
, red/green cable.
039 0242 B
4/5
A2-A6
30
30
31
A1
A
30
A
A
039 0243 B
A4
A3
A2
X322
30
16
039 0244 B