EN/3
Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544
Issue date: 04.2001
1.
Important information for the installation of the basic kit
Only for use in the BMW dealer organisation.
The basic kit may only be installed by a specialist workshop that has the required special tools
and manuals (servicing, repair, diagnostics, etc.).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/lines that you install must be secured with cable ties/textile adhesive tape.
If the specified PIN's and chambers are occupied, bridges, double crimps or twin-lead terminals
must be used.
Item numbers refer only to the overview drawings and to the texts next to the appropriate figure.
The hands-free kit is only active if the ignition key is turned to position 1 (terminal R) or
further (from ignition key position 1 the telephone ON signal is simulated on the radio).
The radio then sends the telephone signals to the on-board speakers.
"
The interior trim parts supplied in the trim colour black are also available in other trim
colours and can be ordered using the electronic parts catalogue (EPC).
"
These installation instructions are only valid for cars
-
without
an on-board monitor radio with a production date after 9/00 or
-
with
an on-board monitor radio with a production date after 10/01.
"
The power supply wiring harness
B
is only required for
BMW 5 Series touring (E39/2)
LHD cars.
"
Subject to technical modifications
Tools and requirement required
MoDIC III or DIS
Cable lamp
Set of Philips screwdrivers
Sharp knife
Set of flat screwdrivers
Set of drill bits 1 – 10 mm
1/4 inch socket set
Drill
Set of Torx sockets
Textile adhesive tape
Angle cutter
Step drill, diameter 30 mm
Combination pliers
