7
M1: Steel/Cast Steel
M2: Cold Work Tool Steel
M3: Stainless Steel
M4: Grey Cast Iron
M5: Cast Iron nod.
M6: Cast Alum. Alloys
M7: Brass
M8: Bronzes
M9: Wrought Copper All.
6.5
Hardness Scales
After pressing key M into item CONV, press C to change the hardness scale
(HLD-HRC-HRB-HB-HV-HS-HRA-σb).
6.6
Average times
After pressing key M into item AVER, press C in turn to select the average times from 0-3-4-5. Selecting 0
means no average values.
6.7
Memory
After pressing key M into item SAVE, press C in turn to switch between On and Off. Selecting On means
memory is activated. HARTIP 1500 can save 99 values in its memory and these stored values can be read
after work.
After memory is activated, -00 will be displayed on down-left corner of LCD while measuring. Take
measurements, all values will be stored automatically in memory.
6.8
Review Stored Data / Delete Stored Data
After pressing key M into item MEMR, press C to read stored data. At same time, press key M or C to recall
stored values forwards and backwards. If no data stored, NOD displayed on LCD.
Press and hold key M or C to exit data review mode. Press and hold key M and C simultaneously to delete
stored data.
6.9
Check Serial Number
After pressing key M into item SN, press C, serial number will display on LCD. Press M to enter next item.
6.10
Restore Default Settings
After pressing key M into item DSET, press C to switch between ESC and RDS. ESC means Escape, RDS
means restore default settings. Press M to confirm.
