BMPRO TrailSafe, Owner'S Manual

Page: 17 / 24

TRAILSAFE OPERATIONAL USE WITHOUT SWAYCONTROL
Once the TrailSafe has finished calibrating and is ready for operational use, the
colour of the LED will change depending on the charge state of the battery.
NOTE:
If you are using the Tr alongside BMPRO’s SwayControl, refer to the
TrailSafe with SwayControl
section of this manual.
Standby
mode
The TrailSafe is in standby as no brake activity has been detected
for 1 minute. The colour will change depending on the charge state
of the battery.
Brake pedal
depressed
For 1
minute
The colour will change depending on the charge state of the
battery.
Pin out
A trailer breakaway has occured. The colour will change
depending on the charge state of the battery.
There is a TrailSafe breakaway
switch fault. The LED will flash
both orange and red.
Do not use unit. Replace the
unit.
Battery flat
Always
on
The battery is flat.
Charge or replace the house
battery.
Other
The TrailSafe is in standby, or there
is no power, or the voltage is less
than:
10.5V for Lead Acid batteries
11.5V for Lithium batteries
If necessary, check the
TrailSafe by depressing the
brake.
CONDITION STATUS SOLUTION STATE
The house battery capacity is sufficient for 15 minutes of emergency braking
operation.
The house battery may have insufficient capacity for 15 minutes of emergency
braking operation.
Check the battery to ensure at least 10Ah of house battery capacity is available.
The house battery is not detected or there is insufficient capacity for 15 minutes of
emergency braking operation.
Charge or replace the house battery.
CONDITION COLOUR
17