G2S BPAP Series User Manual V2.1
34 / 43
CAUTIONS!
• Clean the water chamber only after the water in it cools. Make sure that no water enters
the device.
• After cleaning, rinse the water chamber throughly in clean water to make sure that no soap
residue is left; then wipe it dry with a lint-free cloth, so as to prevent calcareous
accumulations.
• Inspect the water chamber for any leak or damage. Replace the water chamber if any
damage is present.
• It is recommended to do daily cleaning of the water chamber.
16.4 Cleaning the Enclosure
Wipe the surface of the device with a soft, slightly damp cloth.
CAUTION!
• The device can only be used after the enclosure is dry, so that no moisture enters the device.
• It is recommended to clean the enclosure once a week.
16.5 Cleaning the Tube
(1) Remove the tube from the device and mask before cleaning.
(2) Clean the tube in warm water which contains washing liquid, and then rinse it in clean
water thoroughly.
(3) After cleaning, air-dry the tube in a cool, well-ventilated area, and avoid direct sunlight. It
takes approximately 30 minutes to completely air-dry the tube. Check whether the tube is
completely dry before re-use.
CAUTIONS!
• It is recommended to clean the tube once a week.
16.6 Replacing the Air Filter
(1) Open the air filter cap to remove the air filter.
(2) Put the new air filter in the filter area, and then place the filter cap back properly.
CAUTIONS!
• To avoid material damage, do not place the spare air filter in direct sunlight, humid
environments, or temperatures below the freezing point. The air filter should be replaced
every 6 months (It may be replaced more frequently based on actual sanitary conditions).
• Operating the device with a dirty air filter may stop it from working properly and may cause
damage to the device.
• Replacing the air filter and filter cap, device must be unplugged.
16.7 Disinfection
Generally speaking, if you have strictly followed the above cleaning instructions, you do not
have to disinfect the device and / or humidifier. If the device is contaminated or used in
