4/8
BMB
Art. 6256.065 e-mo-lift 650
Art. 6256.100 e-mo-lift 1000
Plug for the TV-lift
Plug for the power cord
Plug for the pushbutton
10
9
7
1. Remove the packaging and check all components for completeness according to list of content on
page 3. The TV-lift is delivered partially pre-assembled. Already mounted fasteners are not listed
again. Due to shipping reasons, one only has to attach the TV-holder.
Because of the size and then weight of the TV-lift, two people should do the assembly.
2. Check the operating functions of the TV-lift. Please proceed as follows:
- Place the TV-lift in an upright position.
- Connect the cable of the lift column with the connecting cable .
- Plug the connecting cable in the control box .
- Connect the control box with a power outlet. The control-LED shines green.
- Connect the pushbotton with the control box . Move the lift upward for a few centimeters
and then down again by pushing the „UP/DOWN“ buttons. The control-LED shines red.
3. Attach the TV-lift vertically to a floor board or a back plate using the 6 mounting holes at the sides
of the mounting plate or alternatively the 4 mounting flabs alongside the lift column .
Make sure that the lift column can be extended fully.
4. Make sure when assembling the TV-lift and the control box that there is enough room for the cables
so that they cannot get tangled up.
5. Plug the connecting cables , and into the control box .
6. Check the lift mechanism by extending the lift column all the way.
MONTAGE
