Installing your System
BLY1
Wireless Alarm System
15
Getting
started...
Movement Detector/PIR final setup
The wireless PIR detector has a jumper link, which activates/deactivates the LED. This LED
can be used when performing a walk test in the chosen installation area to make sure you are
happy with detection coverage. To increase battery life, pull this link off after completing the
walk test. The LED will be off when the detector is triggered during arm. Otherwise, leave the
link on, the LED will be on when triggered.
1. While the control unit is powered OFF, remove the control unit front cover again
(see page 9)
2. Disconnect the battery snap connecting the battery holder. Take out the battery holder.
3. Connect the 9V Alkaline PP3 back up battery to the battery clip and place the battery
into its compartment section.
4. If the alarm sounds then enter the factory User PIN 1234 to silence the system
5. Refit the battery cover. Refit the control unit cover to the base.
6. Power up the main power adaptor again.
The control unit will return to standby ready for operation and the POWER LED will remain ON.
Powering up the control unit
IMPORTANT:
To extend the battery life, wireless PIR detectors are designed to
detect once only before entering a “Sleep” condition for two minutes during which the
unit will not trigger. Any movement seen by the PIR during this period would cause
“Sleep” conditions to be extended by a further two minutes. Therefore, a wireless PIR
which is constantly sensing movement, such as a person walking around a room,
may appear to be non-functional; you will find that the PIR will detect normally again
following a two minute period with no movement present.
Wireless Alarm System.indd 16
01/06/2012 10:57
