14
Getting
started...
Installing your System
BLY1
Wireless Alarm System
4. Locate the detector on the back plate and replace the retaining screw at the base of
the
unit.
5. Align the magnet as described above and fix in position with the two screws provided.
b) Wireless Movement PIR Detector
1. Remove and retain the screw from the bottom of the PIR and lift off the cover.
Fitting
2. If you are fitting the PIR in a corner, use mounting
points “A”. If you are fitting the detector on to a flat
surface, use mounting points “B”. The mounting
points are shown by indentations in the plastic
molding. Use a small drill to create two fixing holes
at the mounting points.
3. Hold the base of the PIR in the chosen position,
ensuring that the front of PIR will face towards the
centre of the protected area, and mark and drill two
4mm fixing holes in the wall. DO NOT drill holes
with the PIR in position – the resulting dust may
damage the PIR and prevent it from operating.
Secure the PIR to the wall using two screws
(25mm countersink) and the wall plugs.
4. Replace the electronic module into the retaining clips, ensuring that it is
correctly positioned and firmly seated.
c). Wireless external siren
Fitting
1. Mount the siren base on to the wall using screws or fixings that are appropriate
for the construction of the building. Keyhole slots and slide mount are provided
to assist with positioning. It is recommended that all 3 fixing points are used.
2. Once mounted, move the siren’s power switch to ‘ON’ again for normal
operation at this stage (see diagram on page 10).
Tamper protection fixing
3. The tamper switch will touch against the wall, but will not ‘click’ in position at
this stage, provided the wall is a flat surface.
4. When the front cover is fitted and the cover screw moves further in, it will push
the wall tamper switch down against the wall making it ‘click’. This screw when
fully tightened, provides front cover and wall tamper protection.
A
B
NOTE:
Each time this screw is removed, an alarm will be triggered by the system.
Silence the alarm by entering the user PIN code at the control panel
(factory set PIN 1234).*
NOTE:
If you are fitting the unit to a PVC door or window, you may wish to use
STRONG double-sided tape to fix both detector and magnet in position.
80.5mm
Siren front cover
Siren base
Wall mounting points
Siren top view of front cover
screw when inserted pushes
down the tamper switch
Cover screw
Front
cover
retaining
screw
Wireless Alarm System.indd 15
01/06/2012 10:57
