Bluworld WATER WONDERS Waterfall Manual Download Page 8

 

Copyright © 2009 Bluworld of Water, LLC. All rights reserved. 

 

similar product may be used with a soft bristle brush to remove any mineral deposits that may 
have developed.  It is recommended that you use Fountec™ to prevent the formation of algae in 
conjunction with Protec™ to prevent the build up of mineral deposits.  For your convenience, we 
have Fountec™ readily available.  Please call customer service. 

 

b.

 

Water Wonders Fountains 

Check to make sure there is no debris blocking any of the grooves.  If calcium or algae has built 
up in the groves, use a pipe cleaner to carefully remove the blockage.  Use caution as to not 
damage the panel as the slate is very thin and can be brittle.  It is recommended that you use 
Fountec™ to prevent the formation of algae in conjunction with Protec™ to prevent the build up 
of mineral deposits.  For your convenience, we have Fountec™ readily available.  Please call 
customer service. 
 

6.

 

Dirty  filter (Water Wonders units, Trellis, Be

llezzas,  Contempos, Watergardens, Piavascos and 

Serrano Horizontal fountains do not have filters). 

 

Remove re-usable filter from pump, clean and re-install. 

 
7.

 

Pump is clogged or malfunctioning

 

 

Refer to pump cleaning instructions.  If still not working, unplug the fountain contact customer 
service. 

 
 

WATER FLOW IS TOO SLOW/FAST 

1.

 

Flow valve is not set properly

 

 

Locate the water flow control valve between the pump and the inlet hose.  

The flow valve on Water 

Wonders fountains, Table Tops , Bellezzas, Piavascos and Water Ga rdens is a black  disc located on 

the top of the pump.

  Turn the valve clockwise to slow the water flow, counter-clockwise to increase 

it. 

 
2.

 

Blockage in water distribution bar which is located above the panel

 

a.

 

Bluworld Fountains 

 

Remove the distribution bar by carefully twisting the bar back and forth until it disconnects from 
the PVC elbow.  Thoroughly clean the distribution bar and reinsert into the PVC elbow.  You can 
use a pin, pipe cleaner or small wire to clean any debris from the holes in the manifold distribution 
bar.  A long, narrow brush may also be used to clean the inside of the pipe.  CLR or any other 
similar product may be used with a soft bristle brush to remove any mineral deposits that may 
have developed.  It is recommended that you use Fountec™ to prevent the formation of algae in 
conjunction with Protec™ to prevent the build up of mineral deposits.  For your convenience, we 
have Fountec™ readily available.  Please call customer service. 

 

b.

 

Water Wonders Fountains 

Check to make sure there is no debris blocking any of the grooves.  If calcium or algae has built 
up in the groves, use a pipe cleaner to carefully remove the blockage.  Use caution as to not 
damage the panel as the slate is very thin and can be brittle.  It is recommended that you use 
Fountec™ to prevent the formation of algae in conjunction with Protec™ to prevent the build up 
of mineral deposits.  For your convenience, we have Fountec™ readily available.  Please call 
customer service. 

Summary of Contents for WATER WONDERS Waterfall











Reviews: