635 W. Michigan Street Orlando, FL 32805 · 888-499-5433 http://shop.bluworldusa.com
Page 3 of 10
Fig 2.1
Fig 2.2
Fig 2.3
Fig 2.4
1.
Your Triple Nojoqui Falls
fountain is 58”
tall x 76.5
” wide. Determine where on the
wall the fountain will be mounted. You may
wish to block out the dimensions with low
tack or painters masking tape for
reference. The fountain must be mounted
into studs, wood or metal. Using the stud
finder locate and mark the position of the
vertical and horizontal studs within the
blocked out installation area. Once the
studs have been located, the brackets can
be installed.
2.
Mark the center of the fountain’s width (Triple is 38.25” - half the 76.5”overall fountain width) for reference. Using
your level mark this line vertically within the installation area.
3.
Identify the Bracket Template (A) from the fountain components. The top of the bracket (A) will rest
exactly 4” down from the overall height of your fountain. Using the center mark of the fountain’s width
place the Bracket Template‘s (A) upper keyhole so you can see the center line through the hole. The
keyholes should be in this position (Fig 2.1). Mark the top keyhole.
4.
Using a Phillips screw driver and a small screw from one of your Hardware Bags (J) set the screw in the wall so
that ¼” is left protruding. Hang the Bracket Template (A) from this screw (Fig 2.2) making certain the keyhole is in
the position shown in Fig 2.1.
5.
Using the level make certain the Bracket Template (A) is vertically level and mark the placement of the lower
keyhole for the reservoir bracket. Remove the Bracket Template (A).
6.
Again using a Phillips screw driver and a small screw, set the screw in the lower keyhole mark so that ¼” is left
protruding.
7.
Hang the Stone Wall Bracket (B) from the center keyhole on the upper screw. Note the position of the marked wall
studs through the numerous bracket holes. (Fig 2.3)
8.
Place the level on the top of the Stone Wall Bracket (B) insuring it is level (Fig 2.3). Mark the holes that align with
the wal
l studs. The ideal bracket installation would include screws located at the bracket’s left top and bottom, right
top and bottom and center. If you do not have studs at
these locations you will need to use the EZ Anchors™ (J) to
complete the Stone Wall Bracket (B) installation at these locations. Remove the keyhole screw as it will interfere
with the installation of the stone.
9.
Repeat this procedure for the Reservoir Wall Bracket (D) (Fig 2.4). Remove the keyhole screw when finished.
Section 2: Mounting the Wall Brackets
