HMXL44-KIT V2
USER MANUAL
05
contact
[email protected] / [email protected]
HMXL44AB-V2
HMXL44AB-V2
The HMXL44 V2 main communication ports are located on the rear panel and includes the following connections:-
Connections:
A.
Global IR Input 3.5mm stereo jack - For control of the Matrix Switcher*
B. TCP/IP – For control of the Matrix (RJ45 Connector)
C.
RS-232 – For control of the Matrix (9 pin serial connection)
D. IR Input (3.5mm stereo jack) for IR pass-through to the associated output
HDBaseT Receiver*
E. IR Output (3.5mm mono jack) for routed IR control of source equipment*
F. RS-232 (3-pin Phoenix connector) for 2-way RS-232 pass-through to the
associated output HDBaseT Receiver
*Note -
Blustream products use 5V IR hardware. For further details please see
page 9 ‘Infrared Distribution’
Blustream HMXL44 V2 Matrix is supplied with all required 5V IR emitters,
Receivers and IRCAB cables
TCP/IP
The Blustream HMXL44 V2 Matrix can be controlled via TCP/IP.
For the full list of protocols please see ‘HMXL44 V2 Control Protocols’ located at
the rear of this manual.
The HMXL44 V2 Matrix features a built-in web browser user interface allowing con-
trol and configuration of the matrix. For further details please see page 18 ‘Web
Browser User Interface’.
A ‘Straight-through’ RJ45 patch lead should be used
RS-232 2-Way
The Blustream Matrix can be controlled via a 9-pin serial cable.
For the full list of protocols please see ‘HMXL44 V2 Control Protocols’ located at
the rear of this manual.
Details of RS232 pin assignment and communication are adjacent. Please note
that depending on your control device serial port pin configuration you may
require either a ‘Straight’ RS-232 cable or ‘Null-modem’ type.
HMXL44 V2 Control Ports
BLUSTREAM RS-232
REMOTE CONTROL
CONSOLE
PIN
Assignment PIN Assignment
1
NC
1
NC
2
Tx
2
Rx
3
Rx
3
Tx
4
NC
4
NC
5
GND
5
GND
6
NC
6
NC
7
NC
7
NC
8
NC
8
NC
9
NC
9
NC
Baud Rate:
57600 bps
Data Bit:
8-bit
Parity:
None
Stop Bit:
1-bit
Flow Control:
None
A
B
F
D
E
C